427ci LS2 sleeved, dry sump oil pump, engine build & install, 69 Camaro

[Flash68]

That is a bad mother trucker right there.

[DaleTx]

Originally Posted by Flash68

That is a bad mother trucker right there.

Thanks.... Yea it keeps my attention

[Rybar]

Again very nice motor Dale, you in Vancouver, BC, Canada or Vancouver, WA?

[Rod P]

I likey

[Track Junky]

Whats the word Dale. Real interested in that spindle and steering arm set up.

[DaleTx]

Originally Posted by Track Junky

Whats the word Dale. Real interested in that spindle and steering arm set up.

It’s has been a while since I’ve posted in this thread. I took the car apart this past winter for some upgrades and still do not have it back together (getting close though).

My goal was to upgrade the 45 year old GM front spindles to some stronger spindles with higher load rated bearings.

I ended up buying a complete package from Ron Sutton Race Technology. Ron designed new custom front spindles, and a brake package to work with my stock front sub-frame and Global West Tubular A-arms. The geometry of the spindle is optimized to improve handling over the stock spindles, and the steering arms are adjustable so I can fine tune the steering ratio (quicker for autocross... slower for road course). The new brake package will increase my total braking torque from 2352 to 3404 (major improvement... can't wait to try them out!).

Some of these pictures are posted in the chassis and suspension section under "front suspension & steering geometry" but I wanted to update this thread to.

Here is some pictures of the new parts:

Spec 37 rotor with custom billet hub.






Wilwood large 6 piston calipers






Howe upper & lower ball joints. Low friction coating... bigger diameter. Stock upper ball joint shown on lower left.



Billet aluminum steering arm



The steering arm has an insert that you can swap out to change the location of the tie rod mount. This allows fine tuning of the steering ratio. This pic shows the caliper mounted to the spindle.




Custom optimized spindles






Large diameter spindle



Massive Timken tapered cylindrical roller bearing






Now I have all the parts in my possession... I'm back from vacation and I’m working to get the car back together.

Upper ball joint mounted


I plan to install the rest of the parts this week. I'll post pics as I go, and provide more info on the adjustable length steering arms.
Look forward to trying out the new parts very soon. Kudos to Ron!

[Vince@Meanstreets]

looking good. thats some serious shheet right there. I think Gaetano's dreams were just shattered. LOL

[Track Junky]

Originally Posted by Vince@MSperfab

looking good. thats some serious shheet right there. I think Gaetano's dreams were just shattered. LOL

Negative Ghost Rider. Pretty sure we'll be headed the same direction.

[Track Junky]

Was wondering when you were going to turn up. That's some stout hardware. Looking forward to seeing it come together.