Man that thing is cool. I have been building a truck with all C6 stuff. The C5 is almost the same. You know you talked about widening the body but why don't you just narrow the track width so it is all in the stock body dimensions. Just a thought, I got my Track width down to 60" ( from 68") I know you could get an inch or 2 more if needed. By getting rid of the cradles you can set the ride height pretty low and have tons of ground clearance. Man your shop looks super professional. I look forward to seeing more on your project. If you need some help with anything let me know. I could almost write a book with all I have learned from building mine, but I can't spell and my hands are to big so I hunt and peck the works out. My project is listed under C6-57. it should......... be at sema this year.
I have been tracking your project for a while dude. I actually have a book in the shop with pictures of other peoples' rides (many from Lat-G) that are doing simular projects like what I'm attempting. I have several of your truck chassic picts that I've been refering to as a guide - thanks ! That will be soooo cool - keep up the great work and I can't wait to see the deal on the road ! GOOD Luck at SEMA you lucky dog ! (wish I could get in there ...)
The reason for splitting the car is because on 356 Porsches - the pax and drive seats are literally touching. In order to get the torque tube down the middle - I'll need to widen the car at least 10 inches to seperate the seats. Other then that - I really don't need the stock vette track width. If I widen the car as stated - the stock vette track width is just right. I might shorthen it a bit so I can get a slightly deeper lip on the face of the wheels just for appearance - but the stock Porsche turbo wheels don't have much anyway.
One of my main problems is lowering the steering rack down so I can move the engine forward and over the rack. I have an LS1 front sump pan from a GTO that will let me move it forward - to gain some foot well space if needed. Once I get the upper arms set in their stock locations - I'm ready to set the body on the jig and start cutting !
You might want to look at my Cuda set up. We used a direct drive dragster can with a Lenco main drive so we could run a driveshaft instead of the torque tube. We also ran the exhaust in the tunnel with the driveshaft sitting over them. We have 5" of ground clearance on a car that sits lower than most guys with 2" or so. Since it's a transaxle you can get by with a 3" or smaller shaft. It's a little noiser than a torque tube but it saves a lot of space and makes maintenance a lot easier. BTW are you cutting up that cute little sunroof car?
Last edited by bob johnson; 07-04-2006 at 08:39 AM.
It takes some time but they come around . I was the first guy to put flames on a Porsche.. it got some me some strange looks with up turned noses but all the people in that world who to me counted loved it.. and I dig what Jim is doing! My secretary has a 356 Conv D and I have two 935's and a 962 in the vintage stable.. so I am a guy who likes a littel power with my Porsche's . Keep us posted on your project I think it is cool as can be . Here's is my boat rocker
__________________
Burn Rubber Not Your Soul
A bunch of Camaro's
Porsche 962
Porsche 935
Porsche IROC series RSR (Fittipaldi)
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Hybrid Mode
