Engine point straight back? - Lateral-g Forums

71455Formula · #1 12-30-2014, 01:24 PM

What motor did you install? Traditional Pontiac or an LS?

**andrewb70** · #2 12-30-2014, 03:30 PM

Quote:

Originally Posted by 71455Formula

What motor did you install? Traditional Pontiac or an LS?

According to his sig, it is a LT1.

Andrew

**WSSix** · #3 12-30-2014, 03:38 PM

Yes, just my LT1/T56 combo. I used the Chevy mounts and holes in the factory subframe when switching from the 403 Olds/auto setup.

Vince@Meanstreets · #4 12-30-2014, 04:07 PM

is the tailshaft centered in the tunnel?

**WSSix** · #5 12-30-2014, 05:27 PM

Dunno. I can find out. UGA's at halftime. I better make it quick. BRB.

**WSSix** · #6 12-30-2014, 05:49 PM

and that's a no.

Should it be though? I thought the tunnel was centered with the car and that because of the offset to the passenger side, the tail shaft, drive shaft, and pinion gear/rear end yoke would be offset in the tunnel as well.

**WSSix** · #7 12-30-2014, 06:13 PM

Did a quick measurement of the trans mount location between the frame rails. It's currently offset approximately 1 inch to the passenger side.