64 Chevelle

[64mali]

Got my Centerforce Dual Friction clutch in for good

[MOREHORSEPOWER]

You have a lot of good ideas going on here !! I wish we was this far along .

[64mali]

[pro66tour]

Fresh wiring looks great going in there! I think I mentioned this before, but love that shot of the rear quarter. I get messy everytime I see it lol

[waynieZ]

Nice job on the panel, it looks good installed. That's a sweet clutch set up.

[64mali]

Thanks guys. I'm hoping to get the trunk floor finished up this weekend and finish painting the under side. That'll be a huge moment when I can really start rolling on the assembly.

[Centerforce]

Originally Posted by 64mali

Got my Centerforce Dual Friction clutch in for good

Awesome! Let us know how you like it once the cars up and running.

[64mali]

Not super happy with the trunk floor pans I got. There's a couple subtle differences like an extra drain hole in the middle and the raised beads on the bottom ran too high in the back. They prevented the pan from sitting flush against the rear cross member. So I had to break out the torch and hammer and flatten them out. Other than that they fit good and I sectioned it in a way that from underneath you could never tell they were replaced. I can make the inside undetectable as well but I'm not going to spend a ton of time on the top because I'm gonna Dynamat the floor.

[64mali]

Flattening them out on the end worked out well and most of what you see was covered by the cross member , including the butt weld

[pro66tour]

With what you had in front of you, you have to be happy with the outcome. Looks like the rest of the build, CLEAN...