Engine, transmission and rear end are in. Setting drive line angles measuring for the driveshaft, fabricating the tunnel to the Tremec., but first we looked for a trans cross member. We looked for something strong but would allow enough room for a 3 inch exhaust to tuck nicely under the floor. The bottom cross member came from Bowler, the middle Chris Alston and not sure where the top one came from.
Last edited by colorado80439; 11-02-2022 at 06:44 AM.
The Following User Says Thank You to colorado80439 For This Useful Post:
After test fitting the transmission cross-members we decided to go a different direction and Kennedy fabricated a cross-member that's welded to the floor and rockers. In a discussion with Sled Alley it was suggested to use a rubber transmission mount to avoid vibration issues.
Last edited by colorado80439; 11-02-2022 at 07:22 PM.
The Following 6 Users Say Thank You to colorado80439 For This Useful Post:
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Hybrid Mode
