67 c10 project

[ironworks]

It looks like a good start. If you wanted to clean them up a little you could go back and change some of the sections where you have multiple parts tacked togther. Get rid of 2 sections with one. When you get experienced you should be able to use a section of the bend with a straight section and have the least amount of weld seems possible.

That SPD tubing work good for tube fit up, huh?

[abadsvt]

Originally Posted by ironworks

It looks like a good start. If you wanted to clean them up a little you could go back and change some of the sections where you have multiple parts tacked togther. Get rid of 2 sections with one. When you get experienced you should be able to use a section of the bend with a straight section and have the least amount of weld seems possible.

That SPD tubing work good for tube fit up, huh?

Since i am going to grind down the welds to make them look like they were bent that specific way I think they will be fine. I can definately see the more you do the easier it would be to cut the right cuts and so on.

Yeah that SPD tubing was SWEET!!! They lined up very well and i used a tubing clamp that was tighten so i can barely move it around to keep my cuts square if that makes sence. So everything lined up really nice on the inside and outside. I would definately use there product again!

Josh