Rear axle catch can-breather ideas?

[jlwdvm]

I had to remove the original breather that Strange installed on my new 9" because it was in the area that I had to weld on tabs for an upper arm. I will be drilling and tapping a new hole in the axle tube and need some ideal on what to use for the axle fitting, catch can, etc. I have cage tubing in the trunk area that the can could be mounted to and some lift over 6AN PTFE hose that I could use if needed. Any ideas?

[Ron in SoCal]

AME makes a nice compact unit. The key is to mount it high so not much fluid fills the can. OTOH you could look at a Morso unit which holds more volume.

[Vince@Meanstreets]

Put the feed hose at the very bottom of the tank so the fluid will drain back down.

[SlowProgress]

Nobody mentioned either one of these. They are costly but both built really well. Several designs available. The Finch version can vent two devices.

[jlwdvm]

Do the II Much pieces just vent, or is there also some storage if lube makes it all the way up?

[Ron in SoCal]

It's a vent only. From experience lol