69 FASTBACK (project 57)

[aussiebj]

for now that will be the final design on the motor mounts untill i get headers and see how they fit....

[rjardy]

Originally Posted by andrewmp6

Its fine for a drag car try carving corners in a newer mustang you'll see why most use a 3 link.

I just saw this. Triangulated 4 links handle just fine. Even better if you set it up properly.

[aussiebj]

Its now a roller and sitting under its own weight,still need to finish up the upper mounts and gusset the corners but now i can roll it in and out of the garage ,i hope to have the body back on the frame this weekend...here are some pics.


Rh lower fwd mount

LH lower fwd mount

[aussiebj]

couple more pics..
shot from rear

Coil over mounts with 3 more inches of height adjustments

[Blue70]

Looking good!!

[aussiebj]

Heres what 2 afternoons and some 1/8th plate can turn into ..finished the LH upper rear mount...

[aussiebj]

Fabed up the RH upper mount today ,I am going to put the body on tomorrow...

[aussiebj]

11/23/08 update set about mounting or aleast setting the body on the frame ..here are the progression pics......
moved frame outside..

lift body up


body comming down

need to remove some tired metal

[waynieZ]

It looks nice sitting on there

[aussiebj]

Hope everyone had a good Thanksgiving...got back to work on the stang ..
Today i removed and replaced the driver side inner and outter rocker
Rusty Rocker

Rocker be gone

Test fitting up the completed piece

And "whala" here is the new rocker installed