I'm a first time welder, so I'll take and input you guys can give me. My camera is focusing very well ( i need a new one) so the close ups are not very clear.
One rookie mistake I made was using a grinder to take off the paint and made some spots too thin around the toe board area. I burned through the metal even on the lowest setting on the welder. What do you guys recommend? Should weld in a strip over the current weld?
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Some floor work
Hybrid Mode
