What I did was make a template of the profile of the floor of the Camaro where the old frame rails were removed. I took the template to AME and they bent the 2x3 rails to my specs. I think they gave the template back to me but I don't remember. I will look to see if I still have it. I thought that Don (since retired) told me they were going to keep the information but since it was a template and not a CAD drawing, probably not. Nothing keeping you from doing it the same way as I did though. Craig Morrison, any comments?
Please, what's with the Mr. Mitchell crap. Perry will do just fine.
Last edited by Perry Mitchell; 01-17-2009 at 01:01 PM.
|
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Threaded Mode