Rad Rides 56 Chrysler/Viper Pics inside Incredible!!

[joe440]

well if the owner wants to drive it thats more understandable and (to me)10 times cooler

[G-Body]

Looks like its going to be at the Mich. for the Ridler after all, from the looks of there updated site at Troys. Dew to the fact that the wisconsin deadline was looking a little unrealistic the owners decided the quailty of the car was more important instead of rushing the build they would reveal it at Detroit

This should make for an interesting show anyone know of any other high end builds heading to detroit this year or is everone keeping there builds hush hush? Could be back to back!

[Mizfit]

good job guys great car so far

[notorious1970]

It will not go for ridler because it was shown in columbus as said by a few peeps on here. THe bottom is speedlined the color of the chassis, because Roger is going to drive the hell out of it. I spoke to jared on the cell a few days ago..the electronics he is doing is going to be sick! The detroit show is going to be great..if you can go, be sure to. The 56 and the nova are going.

[notorious1970]

[JayR]

Originally Posted by Juxtaposed

I'll have to double check, but if memory serves me correctly (I'll have to check with Bob Millard) the last update to the rule was that the car couldn't be in paint and publicly shown or in print prior to the show. Bare metal is fine. All that changed after after Chip won with the Grandmaster. That car had been seen in print in baremetal. So last I knew, as long as it hadn't been publicly shown or in print while painted, it was okay. However, I could be wrong.

In print is fine and very common but at a show is where they draw the line.

[buickfunnycar.com]

been following this one from the beginning...wouldn't expect anything less from Troy's shop...those guys are metalwork masters.

stunning...absolutely stunning.

[slownova]

****ing wow.

[waynieZ]

Very Nice

[4cefed]

So what happens when they go to adjust the control arms on this thing? Does the paint scar badly? Or is the caster,camber and toe all setup when the thing is in bare metal still and just referenced for reassembly via alignment holes?