ATS spindle help

[camcojb]

McMaster Carr has them, give everyone an open account. I get my stuff overnight, they have warehouses all over the US.

http://www.mcmaster.com/#94830a550/=qh0i6

Jody

[Blake Foster]

try ARP from your local speed shop

[akrapovic]

Thanks for the replies gentleman. I believe I actually need the hub stud nut that is described as flexloc thin height nut m12-1.75.

Is this the same one?

http://www.mcmaster.com/#94235a120/=qtfdr

Once again thanks in advance.

[camcojb]

Originally Posted by akrapovic

Thanks for the replies gentleman. I believe I actually need the hub stud nut that is described as flexloc thin height nut m12-1.75.

Is this the same one?

http://www.mcmaster.com/#94235a120/=qtfdr

Once again thanks in advance.

if that's the correct thread then that should work. I would measure the height of one of your existing ones to make sure 15mm is correct, but that's the only one in that thread and style that McMaster offers.

Jody

[akrapovic]

The flexloc nut is .375 so no go on that part. No answer at ATS, also for some reason the voicemail is not working. Ah well I'll get a hold of them sooner or later I suppose. This is fking ridiculous I can't find this flexloc anywhere.........If anybody gets a hold of ATS please post, others have been there but it is annoying to have such a small part hold up your project.

[speedjohnston]

I think they were only going to be open on a part time basis now, that may be why you can't get a hold of them.