Ray Borba's 68 Camaro (Which Koni Coilovers?)

[projectile]

Thanks. I'm running Part # GMP13. It is a bolt in kit for camaros, comes with shocks and springs and should have the correct spring rate for a big block. I am using a stock height spindle.
The rear half of my car has been modified. It has a custom frame from the front sub frame to the rear of the car. The rear floor, back seat area, trunk, and tubs were removed and replaced with hand formed sheetmetal. 4 link suspension was also added. Rear shocks are part#UR5855P and springs are #12-175/350. Rear coilovers may vary depending on type of suspension, mounting angle, ect...
I built my suspension back in 1997. If I had to do/redo it today, I would be looking at a DSE kit. Hope this helps.