New Vendor Sponsor--new Vintage

[redfire69]

Nice looking products. Do you have a 6 gauge setup that will fit into the two bezels of a stock-like 69 camaro dash panel?

[marks914]

Originally Posted by redfire69

Nice looking products. Do you have a 6 gauge setup that will fit into the two bezels of a stock-like 69 camaro dash panel?

69 had 2 big gauges on each side and the rest were on the console I believe, so to run one of our 6 gauge kits, you would need a panel like a Covan's or similar. I would either modify Camaro panel or just get an aftermarket one and fit the 1969 series in there. We are working on a direct-fit setup with 2 gauges, but its not quite ready for prime time, another week or so. We can perform the install to the panel if needed.
Hopefully this helps
Mark

[redfire69]

I was thinking of running just the two big gauges with all six indicators like you have shown above for the datsun. I'd like something that would fit in a modified stock dash.

[marks914]

Originally Posted by redfire69

I was thinking of running just the two big gauges with all six indicators like you have shown above for the datsun. I'd like something that would fit in a modified stock dash.

Sure, send we can do that, just let me know what gauges you want and we can come up with a plan.
Here are the 3-1s with the Camaro theme on them, still rough though.
Mark

[redfire69]

Originally Posted by marks914

Sure, send we can do that, just let me know what gauges you want and we can come up with a plan.
Here are the 3-1s with the Camaro theme on them, still rough though.
Mark

That's exactly what I had in mind! I'll be in touch- Ron

[70rs]

Mark, what is the total outside diameter on the gauges show above? Those are pretty cool!

[marks914]

Originally Posted by 70rs

Mark, what is the total outside diameter on the gauges show above? Those are pretty cool!

It depends,
Those were 4-9/16" hole which I believe works out to about 5" OD (see installed in 67-68 below. We can build those right now, but once we open them up and reface the warranty is void. They are also expensive (retail for about $600.00 for a custom set) to purchase, reface and install. They are a good product, just if something goes wrong we do not have any recourse with the manufacturer.
We are working on a set that is basically the same but we will build here in house that is 4-3/8 mounting hole, 4-3/4 OD. They will have full stepper motor technology and be available in through the dial and perimeter lighting.
Mark