Project Dullboy - Lateral-g Forums

GM Muscle · #1 03-18-2010, 03:01 PM

well i havent had a whole lot of extra time but i am trying to get my acc drive together. this is where im at. what do you guys think? i am going to get the alt where the a/c used to be and think im going to use the 3rib section of the crank to run it. any opinions?

GM Muscle · #2 03-29-2010, 06:55 PM

well i have my accessories pretty much lined out. unfortunately with the combo of 1" set back plates and wanting to use the 3 rib section of the crank to run the alternator i had to notch the frame.

GM Muscle · #3 03-29-2010, 06:58 PM

here is the drivers side plate i made to hold everything. im only using hand tools, a plasma and a welder so you have to stay open minded. the all thread is only temporary so that i could get the spacing tweaked

GM Muscle · #4 03-29-2010, 07:00 PM

and the passengers side alternator low mount..

70rs · #5 03-29-2010, 09:54 PM

Great progress there! Looking good. What's next?

GM Muscle · #6 03-30-2010, 05:10 AM

I need to put the starter, headers and trans dipstick on and make sure it all fits. Then ill probably install my jessel rockers and I'm going to have to get fancy with my cooling lines in the 4l80e! I have a ton of work left on the car but I'm just doing it one chore at a time. Starting up front and working my way back. I'm doing the car alone so it gets overwhelming if I start thinking about everything that needs to be done! Haha

Sti_Guy · #7 03-30-2010, 08:18 AM

Quote:

Originally Posted by GM Muscle

I'm just doing it one chore at a time. Starting up front and working my way back. I'm doing the car alone so it gets overwhelming if I start thinking about everything that needs to be done! Haha

Know the feeling all so well! Good luck! Keep plugging forward!