68 Camaro Project

[johnnymac46]

Its been a while since I have updated..

since my last post i have assembled the front suspension, minus the steering linkage which a buddy of mine is sandblasting some the parts.





I started on the mini tubs, i have one mocked up it still needs some trimming and fine tuning. I still have to cut the floor for the right tub, I began to remove the frame rails for the AME rear which I should have this week.





Im going to wait to weld the tubs in until i get the suspension in. I am still debating if i can save the quarters or if i just want to replace them someone did a pretty terrible job of patching them. the outer wheelwells will definately need to be replaced.

Is there a way to roll the 1/4 lip without buying the 300 dollar tool im going to use one time and never touch again? ive been told that I will regret cutting them.



sorry for the bad pics I took them on my Iphone