Heim joint clutch rods

[ccracin]

Originally Posted by Sieg

I was hoping to source some smaller bungs similar to these:


That would make the project pretty simple.

Thanks for the assistance.

Go here: http://www.ubmachine.com/tierodtubes.html

I think these will make it even easier. If they have the right size for you, obviously. Hope it helps.

[Sieg]

Originally Posted by ccracin

Go here: http://www.ubmachine.com/tierodtubes.html

I think these will make it even easier. If they have the right size for you, obviously. Hope it helps.

Thanks Chad! I think they're a little on the big side but I like that company. Thanks for another resource.

[BonzoHansen]

Originally Posted by Sieg

Didn't see any on their website. I saw them somewhere and can't find the link, heim jointed adjustable. Though it was from one of Lat G's sponsors.

Edit - Found them:


http://cmc.speeddirect.com/itemdesc....%2D125&eq=&Tp=

I saw that Mary Pozzi made her own, I'm tempted, but for $90 these appear decent.

I have this, replaces the stock rods. I thought it made a nice difference on clutch pedal feel. I'm sure if you have the parts & ability there is not much to it.

[David Pozzi]

Here's my page in doing a first gen clutch rod.
http://pozziracing.com/first_gen_clutch_linkage.htm

[Denvervet]

speedway motors sells the rods and joints....just got to figure out what sizes you need.

[Sieg]

Originally Posted by Denvervet

speedway motors sells the rods and joints....just got to figure out what sizes you need.

Thanks, big selection, doesn't appear they have 1/2" OD tube, closest I found was 3/8" thread 3/4" OD tubing. I'm guessing that's a little too big.

Did find some 3/16" thread 5/16" OD throttle linkage tubing though!