72 Camaro Build - Page 30 - Lateral-g Forums

skatinjay27 · #**291** 08-11-2011, 05:55 PM

Quote:

Originally Posted by WSSix

Really like the blacked out rear panel. Did the 2nd gen Z28s come that way?

Keep it up Scott you're almost there.

only big block cars got it.... back then having a satin black tail panel was a sign of having a big block car. it was a sin to do it to a small block car but i guess all the ls cars think they found the loop hole.lol

**waynieZ** · #**292** 08-11-2011, 05:56 PM

Great work Scott it looks awesome.

coolwelder62 · #**293** 08-11-2011, 07:12 PM

Quote:

Originally Posted by skatinjay27

only big block cars got it.... back then having a satin black tail panel was a sign of having a big block car. it was a sin to do it to a small block car but i guess all the ls cars think they found the loop hole.lol

I just like the way it looked.I just hope the Number's matching Police don't Arest me.

skatinjay27 · #**294** 08-11-2011, 10:03 PM

Quote:

Originally Posted by coolwelder62

I just like the way it looked.I just hope the Number's matching Police don't Arest me.

lol
remember you've beat the system since its got an ls base motor.

coolwelder62 · #**295** 08-12-2011, 05:18 AM

Quote:

Originally Posted by skatinjay27

lol
remember you've beat the system since its got an ls base motor.

Thank's I need some luck to go my way.

**WSSix** · #**296** 08-13-2011, 09:11 AM

Thanks for the education guys.

DIGI-TAILS · #**297** 08-13-2011, 09:36 AM

good job Scott!!!

73CPCAMARO · #**298** 08-13-2011, 10:46 AM

It is looking good! Almost there

ScotI · #**299** 08-13-2011, 02:50 PM

Quote:

Originally Posted by coolwelder62

Mark the iner fender's are repos from OER.They fit like a saddle on a hog.But its my back spacing that allow's me to run wide frt. rim's.You need narrow frame rail's and corvette style back spacing to get this done.The turning radius is all that the ARG rack & pinion will give.

That's funny right there. I would guess that means the fit quality was less than good?

coolwelder62 · #**300** 08-13-2011, 03:35 PM

Quote:

Originally Posted by ScotI

That's funny right there. I would guess that means the fit quality was less than good?

On the driver side iner fender where it bolts to outer fender lip every hole was about a 1/2 inch.On the pass side the holes for the iner fender braces dont line at all.