Chad's 68 Camaro V3.0 build. LS3 & TCI goodies

[Chad-1stGen]

Originally Posted by Payton King

But I would leave the sheet metal bolted up and drop the subframe out the bottom. Assemble the other with the motor and headers and roll it back in. I have done a few this way and it is much easier.

Nice progress!

I planned to leave the sheet metal intact. However I'm open to advice on how to do it. I would love to be able to roll the new clip with motor and trans bolted up but am not sure how I'd lift the body high enough to clear it while supporting everything properly? Any ideas? Without the motor it will be easy enough. It's the with motor part that is tougher.