JCG Restoration & Customs Project Blu Balz

[Palmers Customs]

Looking good Chris.

[Cris@JCG]

Thanks Alan! Looking forward to seeing that Vette soon.. Insane work as usual from Palmer Customs..

Originally Posted by Palmers Customs

Looking good Chris.

[coolwelder62]

Cris,

[Vegas69]

KILLER work! Have to be honest, don't like the oil lines right above the exhaust collector in that close proximity. Heat sleeve them at the least.

[GregWeld]

Awesome stuff there Cris!

[Cris@JCG]

Thanks Todd.. It was not the ideal place for the oil lines but it was tough finding a spot for them especially where I placed the oil tank.. But I wanted the tanks feed point to be high so that gravity could keep the the oil feed to the engine.. Looked @ it last nite.. We will fab some stainless sheild to help with heat & keep direction of oil from falling in top of the header if we ever get a leak..

Originally Posted by Vegas69

KILLER work! Have to be honest, don't like the oil lines right above the exhaust collector in that close proximity. Heat sleeve them at the least.

Thank you Sir!

Originally Posted by GregWeld

Awesome stuff there Cris!

[Cris@JCG]

Today I had some help from my friends! Ken R was getting all the hoses on the A/C system plumbed & Dennis W was wiring the coil packs that have been relocated.. Most of the interior panels have been made & the headliner got installed yesterday..



Ken Witney from Wire 1 has been chipping away on the all the wiring requirements on the car..

[Cris@JCG]

Here we go Todd.. We did this this morning... the stainless will shield the heat & it will draw the oil to the sides if we ever get a oil leak..

Originally Posted by Vegas69

KILLER work! Have to be honest, don't like the oil lines right above the exhaust collector in that close proximity. Heat sleeve them at the least.

[Cris@JCG]

So underdash wiring pics...

[waynieZ]

I have to wire my car just looking at that gave me a head ache.