Wanted: c5, c6 6spd Torque tube, dead or alive

[nickcornilsen]

Hi
I'm looking for a torque tube assembly. I dont' care if the rubber couplers are shreaded, or if the aluminum tube is broken, OR if the driveshaft itself is no good.

All I need is the bellhousing that bolts to the transmission, the end that bolts to the bellhousing on the engine, the bearings within, the shaft that engages the clutch, the shaft that slides over the transmission input shaft, the coupler flanges that attached to the mentioned shafts. I'll be making a, custom length driveshaft that doesn't go inside the tube.

As for shipping, if you cut the middle of the tube out, so all I had were the two ends (which contain the parts I talked about earlier in this thread) it could be shipped UPS easily.

I figure someone's got to have a bad torque tube laying around?

[Vince@Meanstreets]

Originally Posted by nickcornilsen

Hi
I'm looking for a torque tube assembly. I dont' care if the rubber couplers are shreaded, or if the aluminum tube is broken, OR if the driveshaft itself is no good.

All I need is the bellhousing that bolts to the transmission, the end that bolts to the bellhousing on the engine, the bearings within, the shaft that engages the clutch, the shaft that slides over the transmission input shaft, the coupler flanges that attached to the mentioned shafts. I'll be making a, custom length driveshaft that doesn't go inside the tube.

As for shipping, if you cut the middle of the tube out, so all I had were the two ends (which contain the parts I talked about earlier in this thread) it could be shipped UPS easily.

I figure someone's got to have a bad torque tube laying around?

I don't have everything but I may have some of that stuff on your list. I'll see what I have and let you know.

[nickcornilsen]

Originally Posted by Vince@MSperfab

I don't have everything but I may have some of that stuff on your list. I'll see what I have and let you know.

I'd appreciate that!

[daytonayellaz]

I have a one thats part of the GrandSport Chassis I have for sale here. We have been thinking of possibly parting out the rolling chassis. If so I could sell you what you need for sure. This would be the "Alive" version though only has 2k miles on it.