Need Help with waterjet or Laser Quote Price!!!! - Page 2 - Lateral-g Forums

xtreme · #11 10-23-2011, 06:12 AM

Georgia

Vince@Meanstreets · #12 10-23-2011, 09:46 AM

try Ty at http://www.fletcherscustoms.com/, see if he can help you out.

Have you looked into an Aluminum version? http://stores.ebay.com/Shapiro-Metal...id=p4340.l2563 these guys have been very helpfull and you can drill into this alot easier than the steel. 3 ft wide? For your rear end or subframe?

Vince @ msp fabrication

Bryce · #13 10-23-2011, 01:47 PM

That quote is about right. I pay about that much when I need stuff done for work and I cannot do it in house.

BTW cool name! My middle name is Gantt.

xtreme · #14 10-23-2011, 05:34 PM

Hey Vince, fletcher is down in Valdosta about 4 hrs from me, but thanks for the suggestions. I would have loved to use aluminum but too expensive and got a a "steal" on the plate haha.

Thanks Bryce Ive never met another Gant, plenty of grants though. Take care.

Check it out guys this is what I did so far

https://lateral-g.net/forums/show...t=30772&page=6