Scott Mock's rear suspension

[David Pozzi]

This system would turn your rear axle housing into a huge anti-roll bar placing a LOT of stress on the housing perches & up-down forces on the Johnny Joints which is not the best way to apply load to them, it should be push-pull, but they are probably beefy enough to not bend. Roll-bind would be a big issue with this design. When the car rolls in a turn, one front eye goes up, the other down, trying to twist the axle housing. I really hate to say anything negative about someone's product that they have worked hard to produce. I nearly didn't post this but felt I had to put it out there.
David