'68 Camaro - Modern T/A

[Track Junky]

Not to mention the quality photography work.

[Openers]

Originally Posted by Matt.A

Do it. All of the cool kids are getting individual runner setups.

Openers, I love the direction that you have taken with this car. The parts selection isn't half bad either

Matt

Thank you Matt!

Originally Posted by Track Junky

Not to mention the quality photography work.

Hehe, thanks again!

[bonecrrusher]

Are you using a floor jack on those tiles at all?

[Openers]

Originally Posted by bonecrrusher

Are you using a floor jack on those tiles at all?

Yip, not only for liftning the car but also draging/pulling it across the floor.

[coolwelder62]

Very Cool.

[bonecrrusher]

Nice - much better then the epoxy in my garage - I swear I hear that stuff crack everytime I lift up one of the cars.

[Track Junky]

Any updates?

[Openers]

Originally Posted by bonecrrusher

Nice - much better then the epoxy in my garage - I swear I hear that stuff crack everytime I lift up one of the cars.

I was about to get epoxy for my floor, but was advised not to. The concrete floor needs to breathe, especially when it´s on the ground (no basement or story beneath). So I went with tiles instead.

Originally Posted by Track Junky

Any updates?

Nope

[Openers]

Started on the exhaust.

[Openers]

Long time, no...

Been busy with other projects but here is a small update. Installed a rear sway bar so now I can continue with the exhaust.