wedged- 41 Dodge truck project

[wedged]

a few weeks ago I put the bed in place and tack welded it to keep it from moving. Now I can make the brackets for it. I think I've got the cab floor figured out too, now I need a sheet of diamond plate steel.

Didn't get much done this year, but I'm not in a rush.

[wedged]

yesterday I finally got some more done on the headers .











I still need to trim the collector length and add flanges . I'll likely run them awhile and then have them coated.

Here's the driver's side. Originally I thought I might have to get creative with the steering column and shaft, but it looks like it will be easier than I anticipated.




Today I made a couple of bed mounts. The through bolt is sleeved so when it's tightened it will not crush the frame. I need to make 4 more similar to them and then the rear ones will be quite a bit different. I'll finish welding them with the bed removed from the frame.

[waynieZ]

Nice to see your still at it.

[R.A.D]

any updates?

[wedged]

No, but maybe over the next few weekends

[wedged]

rear bed mount. need to add the through bolt of course.

[wedged]

finished the bed mounts and welding in the reinforcement tubes in the frame.

[revmopar]

good to see you still plugging away at it. I bought a couple of old Dodge trucks and have started on the 38 I bought, it's going to be more street rod than pro touring but it should be fun.

[wedged]

had a piece of 14 gauge sheared to fit a portion of the floor. I need to add a hump to clear the trans.

[wedged]

trimmed some more of the old floor away and made a small notch just to get the floor to lay flat. test fitted a seat too.