Does anyone know if there is a company that offers a pre fab tunnel to clear T56 tranny? I have been told that it will probably take about 2" to clear.
Not that I have seen, in the past I have just pie cut the tunnel and raised it up and then filled in the gap. I have also used the trans tunnel repair panel they sell, just cut out the old one and put the new in a little higher. Then you need to adjust the front from the firewall to tunnel a little.
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Threaded Mode