welding stainless steel exhaust

[GregWeld]

Originally Posted by 64pontiac

Good info in here. I do believe you on the exhaust growing Greg, just haven't experienced it myself.

My little '32 doesn't have any flex joints in it... and that's the problem with that particular system. If it did -- it would have been fine.


The "old trick" I've used to figure where the crossover goes -- spray some paint on the exhaust after the collector --- from there back about 18" ---- Run the system -- and put the crossover where the paint 'boiled'. But that was before the days of "X" pipes. And is probably about as scientific as spitting.