Brendon's '67 Firebird thread

[Tuske427]

OK, a month later and I'm finally back in the garage for a little bit- only to discover that somehow I botched my fabrication while building my car. I swear I mocked this up, but when I went to fit my hydroboost unit to the firewall it wouldn't fit. It interfered with the hoop support tube in my engine bay. d'oh! So the cut off wheel came out and I spent most of my time notching the tube to make enough clearance. Now I'm concerned that when I install a master cylinder it will interfere with my inner fender. I just know it will...

After notching the tube I painted it again, and a few more parts today, as well as some foam insulation on mt roof.

Also, in my haste- I've installed my kick panels and e-brake (remembering those go in early), but now I'm thinking they need to come back out as I didn't install the door jam switches for the dome light. While it may be possible to install those, it'll be a lot easier to fish the wire where I want it with them out. So out they'll come again :p