1969 Camaro Headliner

[tubbed69]

Originally Posted by coolclassiccars

well since were on the topic anyone know where to purchase a good steamer.been using a heat gun on most of the headliners , but was thinking of getn a steamer.thanks shawn

good question Shawn I was wandering about getting one also

[Sieg]

Originally Posted by coolclassiccars

well since were on the topic anyone know where to purchase a good steamer.been using a heat gun on most of the headliners , but was thinking of getn a steamer.thanks shawn

Originally Posted by tubbed69

good question Shawn I was wandering about getting one also

I've had two of their professional J-4000DM steamers in the past 30 years: http://www.jiffysteamer.com/

[tubbed69]

Originally Posted by Sieg

I've had two of their professional J-4000DM steamers in the past 30 years: http://www.jiffysteamer.com/

thanks Sieg I will check them out

[TMIProducts]

We manufacture Camaro headliners. All of ours are made here in the USA, about 50 feet from my desk.

We've been selling them for quite a few years and I've never heard the issue that you're dealing with. Sounds like their patten is off just a little bit.

Let me know if you have any other questions!

[tubbed69]

Originally Posted by Tim@TMI

We manufacture Camaro headliners. All of ours are made here in the USA, about 50 feet from my desk.

We've been selling them for quite a few years and I've never heard the issue that you're dealing with. Sounds like their patten is off just a little bit.

Let me know if you have any other questions!

thanks Tim I will check out your website,not sure but may change it out

[Musclerodz]

My issue is not is the center, it was on the side. That can come from not being pulled tight enough side to side.