Project ""Mercury Rising"" 1969 Camaro

[Denvervet]

Great looking setup...esp the intake. I have a similar 572 setup and wonder if you're going to have room between back of the distributor to rout the fuel line there along with the pressure regulator.
I was advised to run the pressure regulator back at the tank to not transfer engine bay heat back into the tank. This setup has worked flawlessly in hot weather with no heated fuel problems nor any engine starving issues.
Just a suggestion.
One other issue I had to remedy was overheating at idle before installing a closeout panel between the core support and the front header panel. I even fabbed up a closeout below the core support too with my Ron Davis radiator.
Good luck and can't wait to see how it all finishes up.