1969 Camaro tru-turn

[Rod P]

I have done some of the extra work here to give everyone one a LOT more info....you have the measurement?? 15 1/8 inches simple if its more than that...then we need to figure out your offset, if it is the same 15 1/8 inches, then you have the wrong offset rims, also simple just re-hoop the wheels, forgeline (or most forge rim builders will re-hoop at minimal cost) and then you can run fatty rims, and Impress friends and influence enemies

[Rod P]

Originally Posted by cwylie

I do think it would be very helpful if ridetech could call out we should be aware of the brake kit that is used and and be mindful of any extra track with that is added when ordering your wheels. It sure could have saved me some trouble.

we did? that's what this whole thread is about and you have said the same thing over and over...

Originally Posted by Rod P

..you have the measurement?? 15 1/8 inches simple if its more than that...then we need to figure out your offset, if it is the same 15 1/8 inches, then you have the wrong offset rims, also simple just re-hoop the wheels, forgeline (or most forge rim builders will re-hoop at minimal cost) and then you can run fatty rims, and Impress friends and influence enemies

didn't you have the 5.250 backspace rims?? I'm the NEW guy but I will tell you if that's your backspace, your rims wont fit you have the wrong backspacing, you read the offset incorrectly you say you have 5.250 because you wanted them .500(1/2) narrower than 5.750, you went the wrong way, to be narrower(more fender space) by .500(1/2) you should have ordered 6.250...the 5.250 is very close to what I have but even then you're still to wide....RideTech recommends 5.750 back space

[Blake Foster]

And they say anyone can build one of these cars, IT's easy, why should I pay you to do it??



CUZ THAT'S WHAT WE (the builders and manufacturers on here. not just Speedtech) DO

no disrespect to the posters but in this game it is ALL about the measurements

[Rod P]

Originally Posted by Blake Foster

And they say anyone can build one of these cars, IT's easy, why should I pay you to do it??



CUZ THAT'S WHAT WE (the builders and manufacturers on here. not just Speedtech) DO

no disrespect to the posters but in this game it is ALL about the measurements

tape measure! cheap tool that makes you look smart and makes parts fit