1969 Camaro road racer

[Vince@Meanstreets]

uhh oh the boss is here....get back to work.

More metal work.

We are closing up the firewall and down bars holes changing a few things around.

One of these changes is the clutch and brake master locations. We were unable to access the brake fluid due to the down bars so we went with a Strange compact dual screw off car master.

Usually I would run a master plate but in this case we needed more room up front so I recessed the clutch master a bit. Should clean the area up too.
Pictures tell the tale.

[Vince@Meanstreets]

....and the passenger side.

quick disconnect MSD 6al mount, starter harness pass through and panel reinforcments.

Closing up the down bar openings.

[1transam]

Nice, shes coming right along!