1970 Camaro-Purpose Built Auto Cross - Lateral-g Forums

Vince@Meanstreets · #1 09-15-2014, 10:26 AM

If the Nomad came out kick ass you didn't waste your time. I see it as an evolution in skill production.

Looking good. You made me realize, I'm pulling the cowl panel next time I do a 2nd gen cage. The A pillars are perfect.

Looking good.

gerno · #2 09-15-2014, 10:36 AM

That cage looks terrific. I'm jealous.

Rick D · #3 09-15-2014, 07:08 PM

Looks great! I'm really liking the cage, I'm still on the fence if I want to put a cage in or not, but if I do I see how I'm going to do it!

Mac&Otto · #4 09-16-2014, 08:21 AM

Quote:

Originally Posted by Vince@MSperfab

If the Nomad came out kick ass you didn't waste your time. I see it as an evolution in skill production.

Looking good. You made me realize, I'm pulling the cowl panel next time I do a 2nd gen cage. The A pillars are perfect.

Looking good.

Thanks. Remember, I had to pull the cowl to replace the roof in the beginning of the build so it worked out perfect. I also was able to repair a spot of rust right under the wiper motor(lowest spot in the cowl with no drain). Hers a shot of the Nomad in progress. Metal work is done and chassis just need a little plumbing, then it's off to paint.

Mac&Otto · #5 09-16-2014, 08:23 AM

Headed to prime.

Mac&Otto · #6 09-16-2014, 08:24 AM

Art Morrison, LS3, 4L65.

Mac&Otto · #7 09-16-2014, 08:29 AM

There is one thing I need to start thinking about and that's a clutch, pressure plate and flywheel. I would appreciate any input I can get. Just remember the primary use for the car is Autocross. Thanks again.

Cal.

Vince@Meanstreets · #8 09-16-2014, 02:44 PM

Sorry to side track the thread but did you have to replace any of the roof section? I have one and would like to see what it looks like under the paint.

If you have time or info please email to [email protected]

Mark Stielow is using Centerforce on his latest build. No sure if an aluminum flywheel is in your budget.

Thanks!

Mac&Otto · #9 09-16-2014, 08:59 PM

Quote:

Originally Posted by Vince@MSperfab

Sorry to side track the thread but did you have to replace any of the roof section? I have one and would like to see what it looks like under the paint.

If you have time or info please email to [email protected]

Mark Stielow is using Centerforce on his latest build. No sure if an aluminum flywheel is in your budget.

Thanks!

My budget was shot a long time ago. I definitely want to run an aluminum flywheel. I thought I would do some searching at SEMA. I'll email you tomorrow on the Nomad. Thanks for the help.