Project 'Grip'- 69 Camaro

[Payton King]

Where is your watts piviot in relationship to axle centerline?

[Stovebolter]

Originally Posted by Payton King

Where is your watts piviot in relationship to axle centerline?

I'll have to check it again but if memory serves me correct, it is just above axle center line. I have air springs.....I could move the mount points up or down but I'd sacrafice travel up or down. I could slow up my rebound and leave my compression where it is. That makes sense. That should counteract the hop. I'll try it.

Thanks again Payton.

[Payton King]

With it above center line you have raised the roll center and loosened the rear. The lower you go the more bite you will have in the rear. Try an inch or 2 below axle centerline. Is your watts fixed or adjustable? I assume your rear trailing arms are level at ride height

[Stovebolter]

Originally Posted by Payton King

With it above center line you have raised the roll center and loosened the rear. The lower you go the more bite you will have in the rear. Try an inch or 2 below axle centerline. Is your watts fixed or adjustable? I assume your rear trailing arms are level at ride height

Yes, trailing arms are adjustable at rear mount....but level at ride height at this time. I may be wrong on the front mounting point. I remember you gave me roughly what yours was set at, and I added 2"s of adjustment in 1" increments both ways and took in consideration the axle centerline. I bet it's below. That would make better sense. I'll check it when I can get to the shop.

And Watts Link has a lot of adjustment.

Thanks.

[Payton King]

I was not speaking about the front mount. I would guess it is 6 to 8 inches from the ground at ride height. I am speaking of the watts pivot in relation to your axle centerline at ride height. The lower the pivot the more bite you will have up to a point. I would start it at or 1 inch below axle centerline and start messing with the shocks.

Increasing the rebound valving like you stated earlier would help as well.

[Stovebolter]

Originally Posted by Payton King

I was not speaking about the front mount. I would guess it is 6 to 8 inches from the ground at ride height. I am speaking of the watts pivot in relation to your axle centerline at ride height. The lower the pivot the more bite you will have up to a point. I would start it at or 1 inch below axle centerline and start messing with the shocks.

Increasing the rebound valving like you stated earlier would help as well.

Lol. I over complicate things often. Yes...the front mount is about 5.5" from ground. At this time the Watts link pivot point is centered with relation to axle center line. I'll try raising it an inch and see what I get with a little more dampening on rebound. Man these TQ shocks are cool. Reminds me of my days competing in the Hare Scrambles via woods MX. Same adjustments available.

[Stovebolter]

Tell me it isn't so...are we going to lose Heartland to the city of Topeka for not paying their bills? I hope they keep it open. If not that puts my closest track with Elkhart. Frustrated.