'67 Chevy II Project

[wiedemab]

earlier pics -- -

[wiedemab]

[wiedemab]

[wiedemab]

I'll just skip ahead. The majority of the DSE Quadra-link is welded in place. The inner and outer wheelhouses, quarters, tail panel etc. is all screwed into place and fit up. A few more things to check and then I'll blow is back apart for the last time, button up some welds and then put everything back permanently.

[WSSix]

Looks great, Brandon. Did you do anything to treat the metal that's hidden, like the inside of the frame rails, since you had access to some of it?

[wiedemab]

The Dynacorn parts either come coated with their weld-thru or the standard new part black (probably crappy - primer). Where I was going to weld or had ground, I either used weld-thru primer or in some cases used epoxy primer.

Could I have coated it more uniformly and thoroughly, probably yes........ Much of the framerails gets welded on to install the DSE stuff and what I had sprayed on the inside of the rails was burning back off in those areas. I may coat the inside of them with

http://www.amazon.com/Transtar-4423-.../dp/B00H2W3YZW

We've used it with some success in the past. I would do this once it is on the rotisserie so that I can spray it from multiple angles etc..

[kevin_l]

Wow, Loads of progress! Your work is looking great, almost looks like a car again. Did you get the lower link mounts welded in yet? The directions are kind of odd there. I had to call and double check a few measurements with dse.