1970 cuda project devilfish - Lateral-g Forums

MoparCar · #1 02-01-2015, 06:51 AM

Looks good. A couple of questions. Does the XV have both camber and caster adjustment? Do you know what the hub to hub (face to face) width is? I originally bought my Fikse wheels set up for the RMS width and just wondering how close it is.

Thanks, Wes

b5devilfish · #2 02-02-2015, 09:51 PM

Quote:

Originally Posted by MoparCar

Looks good. A couple of questions. Does the XV have both camber and caster adjustment? Do you know what the hub to hub (face to face) width is? I originally bought my Fikse wheels set up for the RMS width and just wondering how close it is.

Thanks, Wes

Wes,

camber caster, and hub to hub looks like 62 3/4 that's also sprung measurement I don't know if that will change at ride height I think it would? If your gunna spend the money I think going the xv set up is better in the long run just IMO. I just haven't seen the rms hit a road course, just autocross.

James

Vince@Meanstreets · #3 02-02-2015, 10:10 PM

good looking project. Is that AMD sheet metal being used?

Justin@EntropyRad · #4 02-03-2015, 07:48 AM

That suspension is no joke

b5devilfish · #5 02-03-2015, 09:02 AM

Quote:

Originally Posted by Vince@MSperfab

good looking project. Is that AMD sheet metal being used?

you are correct all AMD only issues i had were the tail panel and the right quarter but other than that all has fit exstreamly well and very straight. i chose them due to the fact of my challenger having a GoodMark front end and the fit and finish of the panels were a joke nothing was remotely close to fitting.

james