OK time for a new rear end suggestions

[Ron Sutton]

Originally Posted by JSM

Ron,
As usual, thank you for taking time to answer, and in detail, but I think I did not ask my question clear enough. I was not needing the entire full floater rear-end set-up weight because I know there are many variables.

What I was trying to figure out is the weight ONLY for the items that I had listed. So basically if you took the components I have listed again, throw them on a scale,,,, what do they weigh?

(1) Snout -
(1) Hub (steel or aluminum? -
(2) Bearings/Races -
(1) Drive Plate & Cap (I assume you run steel) -
(5) Studs -
(1) Caliper Bracket/gussets) -





Thanks in advance, Jay

Hey Jay,

Next time I'm at my shop ... which isn't often ... I'll grab those parts and weigh them. They are going to be heavier than the C6 ends and assembly. I'm just not sure how much heavier.

[Sieg]

I sincerely apologise in advance.......but the title of this thread has been egging me on for days and I could no longer resist.

OK time for a new rear end suggestions

This one from UCLA isn't bad IMHO............



.......again my apologies but............

[Nativefx]

Originally Posted by Sieg

I sincerely apologise in advance.......but the title of this thread has been egging me on for days and I could no longer resist.

OK time for a new rear end suggestions

This one from UCLA isn't bad IMHO............



.......again my apologies but............

Although in the end, that rear would probably end up costing me WAY MORE than I bargained for!!!!

Great view!

[MillerBuilt]

Originally Posted by Sieg

I sincerely apologise in advance.......but the title of this thread has been egging me on for days and I could no longer resist.

OK time for a new rear end suggestions

This one from UCLA isn't bad IMHO............



.......again my apologies but............

Hands down THE BEST option thus far!

[MillerBuilt]

Originally Posted by Ron Sutton

Hey Jay,

Next time I'm at my shop ... which isn't often ... I'll grab those parts and weigh them. They are going to be heavier than the C6 ends and assembly. I'm just not sure how much heavier.

No worries Ron, just figured if they were handy. Thanks!