Engine is out of the car, still needs a final cleaning. There is a few spots on a couple pulleys where the anodizing is bad. I will have those parts re-anodized before shipping engine to its new owner. Price dropped to $18k shipped.
__________________
Mike Redpath
Musclerodz & Customz facebook page
Yes it is 58x. Wegner had their own setup for the dyno and don't remember what they used, so no harness or computer has been purchased for it yet.
Thanks Mike, Most likely the Holley set up.
When was the last time it was run and is that mud I see on the pan? Did it get stored outside at any point? I know its pretty humid in your area. Just worried about corrosion on the cylinder walls.
Here is a video of it being run at Wegner Automotive. The ECU could be Pantera EFI 882, because Lance Nist mentioned that Wegner used their components. You can use a GMPP harness as well. Jeff
When was the last time it was run and is that mud I see on the pan? Did it get stored outside at any point? I know its pretty humid in your area. Just worried about corrosion on the cylinder walls.
It was last run in 2011, and its been sealed the entire time inside my shop. Never been outside. The anodizing issues came from an ex employee who did not protect the engine while either welding or grinding in the engine compartment. Had no idea it was like that until it was removed from the car. I plan to borescope it this weekend for another guy, but I don't think there will be any issues. If there is I would stand behind it and take of it if anything out of ordinary was found.
__________________
Mike Redpath
Musclerodz & Customz facebook page
Last edited by Musclerodz; 09-11-2015 at 05:33 PM.
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Hybrid Mode
