1969 Camaro Restomod Project Thread - Page 47 - Lateral-g Forums

**will69camaro** · #**461** 11-08-2015, 11:27 AM

It's got a bit left yet but it's slowly shaping up.

Few updates. Wastegate dump is done.

Fabricated the close outs for the filters in the fender.

Passenger side installed.

Drivers side installed.

And this is the start of where the filter will be. This is just behind the headlight. Should be plenty of fresh air in there.

Hoping for more progress soon. Should be competing the kit early next week.

randy · #**462** 11-08-2015, 03:18 PM

I made a set of those fender close out panels also. Couldn't believe how simple they were. Maybe if i can figure out a way to scan the template Ill post for everyone else to make. Mine uses the little hole in the fender and secured on the bottom.

Let me know what trim you might put around the edge of it to stop them from rattling on the inner fender

**Spiffav8** · #**463** 11-08-2015, 04:04 PM

Nice! Oddly I was just talking to a couple guys about this over the weekend.

**waynieZ** · #**464** 11-08-2015, 04:43 PM

Quote:

Originally Posted by randy

I made a set of those fender close out panels also. Couldn't believe how simple they were. Maybe if i can figure out a way to scan the template Ill post for everyone else to make. Mine uses the little hole in the fender and secured on the bottom.

Let me know what trim you might put around the edge of it to stop them from rattling on the inner fender

Thanks, I'll be watching for that post.

**will69camaro** · #**465** 11-08-2015, 06:27 PM

Yea GAP racing has made some for stock style core support and attaches at the top. They look excellent. I'll let you know what I end up using for trim if necessary.

**will69camaro** · #**466** 11-08-2015, 06:30 PM

Found a picture of GAP Racings panel.

randy · #**467** 11-08-2015, 08:13 PM

Quote:

Originally Posted by will69camaro

Yea GAP racing has made some for stock style core support and attaches at the top. They look excellent. I'll let you know what I end up using for trim if necessary.

the closeout panels use a nice trim piece. If we can get that exact trim it would be perfect

**will69camaro** · #**468** 11-09-2015, 02:15 PM

Update, intake is on and hardlines going in. Car should be done and ready to be picked up today.

Holley boost control solenoid and MAP sensor/IAT/etc installed below intake.

BOV hardlines run to tapped port on intake

BOV and WG lines hardlines in car

Some added flair for the WG vent

William

**will69camaro** · #**469** 11-11-2015, 08:45 AM

Car is done at M2K, turbo kit finished.

Filter placement is exactly like I pictured it in my head.

And did a clearance check on driveshaft to x-pipe. Looks like it'll have to jump the car to get it contact between the two.

**will69camaro** · #**470** 11-15-2015, 07:10 AM

She's home.