LS3 reduced engine power

[71RS/SS396]

This usually occurs when the ecu sees a difference between the commanded position ( throttle pedal position ) and the actual position of the throttle body, or a complete loss of signal from either one. I'm surprised you don't have a TAC fault of some sort. Is it possible the codes have been turned off?
My car did this intermittently, I found if the secondary safety latch on the throttle pedal plug was not locked in it would periodically loose the signal, ever since I pushed that in on the plug I haven't had a problem. I would suspect either the throttle pedal, throttle body, or wiring.

[rich]

bought code reader. P2127 is the error code. I replaced the accelerator pedal and still have the problem. would you suggest replacing the TB or the TB electrical connector?

[randy]

dont you need to calibrate the pedal? I know i have that option in the solous scanner. Had a chevy HHR that would do that until i replaced the pedal

[rich]

what is the procedure to calibrate the accelerator?

[TomM]

Try unplugging the mass air flow sensor and see if it quits doing it, if so, replace the MAF.....


T,

[rich]

finally fixed the problem. it was a bad wire splice going to the accelerator. Glad to have that off the list.

[randy]

Originally Posted by rich

finally fixed the problem. it was a bad wire splice going to the accelerator. Glad to have that off the list.

Maybe thats the reason they say on the instructions NOT to mess with those wires lol