'05 Vette build thread

[Jon69RagTop]

Can you provide some info on the PVC valve?

[bonecrrusher]

Originally Posted by Jon69RagTop

Can you provide some info on the PVC valve?

Beck / Amley 0450299 PCV Valve

I ordered it at Autozone - but you can prob get a better price on Amazon.

I used some hose worm clamps to tighten the hose down on it - it looks pretty ugly but I hid it under the blower snout.

[bonecrrusher]

Quick update:

After I was tracking down a leak on the PS setup - I saw that my bull bar was was looking like crap.

I took the 4 bolts off - and removed it. I really like the looks of it without the bar on there.

I also decided to ditch the Bro-Truck billet grill. I removed it but the plastic grill underneath looks like crap.

So I painted it with SEM Trim black paint - and will put it back in when it finishes drying.

I also installed the LBZ mouthpiece and updated my 10+ year old cold air intake.

The truck came with an AFE Magnum Force intake - which doesn't look like it has been in production for a long time.

So I found a Spectre Diesel filter that fit in the AFE box - and put in the LBZ part.

I can't say I feel a huge difference - but removing a big restriction in the air path has to help.

Now for the pics:

[bonecrrusher]

I let the grill dry for 24 hours - and installed it today.

For being a can of SEM Trim paint that I had sitting around - I think it turned out pretty well.

That will be it for awhile - I think my next project will be a Corsa downpipe and catback - but that will be awhile.

[bonecrrusher]

Back to the Vette!

I saw that some folks are using the Halltech Beehive intake shroud with there E-Force cold air intakes.

It lowers IAT's by isolating the filter from the hot engine bay.

So I ordered one - and had to modify it because of the front intercooler heat exchanger piping on the passenger side.

After a few cuts with a jigsaw - and trial fitting it - I finished up the install. I also hid the MAF sensor wire under the filter so that its no longer visable.

I went on test drive and had no issue - as I pulled into the driveway I smelled coolant.

I popped open the hood - and saw a cut in the coolant hose connecting the heater core > water pump > coolant expansion tank reservoir.

I must have moved the hose when I was installing the intake - and didn't check for clearance before my test drive.

I sliced the hose - and sprung a tiny leak. I cleaned up the engine bay and I have ordered a new hose. It wasn't super expensive - but a dumb mistake.

I will probably be replacing the hose sometime next week - I don't think it will arrive quickly.

Now for the pics:

[bonecrrusher]

I filmed a couple review videos - one with about my Maxjax lift - and one about my E-Force install, issues, and overall impression.

MaxJax review:


E-Force install/review/mods:

[bonecrrusher]

SS update...

The SS comes with a lot of chrome on it - both on the exterior and interior.

I have already deleted the chrome on the front of the car - but not the interior.

I just finished up removing and installing the following Holden black trim parts.

Touch Screen Navigation surround.
Shifter surround.
Bottom half of the steering wheel trim.

Install was fairly painless - just took the time to be careful and not break anything.

I have to say - it looks way better.

I got these Holden parts from HoldenPartsUSA in California - and I got them in 3 days to NC. That sure beats shipping from down under.

Here are some finished pics: