efi intake for 572 - Lateral-g Forums

Craig69 · #1 11-05-2016, 06:39 AM

Yes I was going with Holley dominator so I would have transmission controller also.

bretcopsey · #2 11-05-2016, 07:15 AM

Not sure whether Arizona Speed's setup would work?

http://www.azspeed-marine.com/fuelinjection.html

Craig69 · #3 11-05-2016, 02:14 PM

No I actually have that one on the motor now and it is about 3 inches to tall. Worked well in the boat but to tall for car. Thanks

l2azorback · #4 11-09-2016, 06:03 AM

I'm running the Holley MPI set-up for a BBC on my Shafiroff 540 Ultra Street and am normally aspirated. A power adder will not work with this set-up with out increasing the size of the cowl hood. I have a factory cowl hood and can barely fit my air cleaner.

Craig69 · #5 11-11-2016, 04:09 AM

Yes I think I am going to have to have one built. I would be ok with about 18 inches above China rail but havent found one yet that would work.

Craig69 · #6 11-11-2016, 05:03 AM

That's wrong. I have about 10 inches from China rail. My bad

Craig69 · #7 11-17-2016, 04:13 AM

Ordered one from Hogan. Thanks for info.

**214Chevy** · #8 01-11-2017, 09:08 AM

Quote:

Originally Posted by bretcopsey

Not sure whether Arizona Speed's setup would work?

http://www.azspeed-marine.com/fuelinjection.html

I once owned this piece, but never installed it. I was a nicely built unit though.