Tom My oil lines are -12 . where you see it is the place with the most clearance to get it to the front. I can't go below the tube because it ends up below the oil pan. I should have made the oil lines for the first 10" out of stainless or aluminum that would have made more room anmd aluminum could have been welded to the pan adapter without fittings.
1Bad68Cat
Even with the BFH it still doesn't have enough room. It would need to be offset in the opposite side 1/2"-3/4" I don't want to change the geomitry of the bracket.
Last edited by waynieZ; 07-18-2017 at 04:58 AM.
|
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Threaded Mode