DWC's 1968 Camaro project - Lateral-g Forums

03-09-2018, 07:55 AM

DWC

Senior Member

Join Date: Jul 2017

Location: South Carolina

Posts: 242

Thanks: 3

Thanked 113 Times in 75 Posts

My Ridetech front end bits showed up the other week. I mocked up the front control arms, spindles, and coilovers to be sure I had proper clearances before welding the Chicane mounts in. Everything looked good so I burned them in.

I pulled the 8.2 rear end and cleaned it up. It was *caked* in crap. Once the rear brakes arrive, I'll pull the axles and replace the axle seals & bearings and the pinion seal.

Daniel

Attached Images

Last edited by DWC; 03-09-2018 at 08:29 AM.

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -7. The time now is 08:38 PM.