Torque arm setup

[62fairlane]

well I have plans to back half the car in a year ot two (just got out of college and once I get loans paid off and an actual garage to work in then it is coming off the road and getting cut up bigtime....shold have loans pretty well paid off in another year) I have all the bits around except for the shocks and some steel (have most just need a couple hunk here and there)

I laid out a tri-4 bar for my sr design project (along with the back halfing, and a front end and all) so that will be going on the car once I get the space to really rip the car apart. I'll post some pics up tomorrow of what I have planned when I can use the scanner at work.

so if I have a 6' or so long subframe conector can I have a TA mount in the middle of that without any major bending moments? I was planning on some 1.0" x1.25" x.120" tubing for the subframes...kinda beefy but they are kinda long and only suported on the ends and will carry the load of my transmission mount and the TA forces)