Agent Orange the Bolt on brawler 69 camaro build - Lateral-g Forums

**CamaroAJ** · #1 02-18-2020, 12:41 PM

Are the Z/28 brembo calipers the same bolt pattern as the C6 ZR1 calipers? I think I'd much rather have those than the C6 ZR1 calipers if they do.

rideordie28 · #2 02-18-2020, 02:14 PM

Quote:

Originally Posted by CamaroAJ

Are the Z/28 brembo calipers the same bolt pattern as the C6 ZR1 calipers? I think I'd much rather have those than the C6 ZR1 calipers if they do.

these are zr1 corvette calipers. they are all the same in terms of rotor and pad size. the difference between them all is the stand off distance for the caliper bracket bolts. so the c7z calipers are basically the same as the z/28 and the c6 zr1.

mine are a c6 zr1 setup repainted bc no one will go to the c7 and 5th gen camaro/6th gen camaro setup yet.

rideordie28 · #3 02-18-2020, 02:18 PM

more pictures

**CamaroAJ** · #4 02-18-2020, 04:00 PM

Quote:

Originally Posted by rideordie28

these are zr1 corvette calipers. they are all the same in terms of rotor and pad size. the difference between them all is the stand off distance for the caliper bracket bolts. so the c7z calipers are basically the same as the z/28 and the c6 zr1.

mine are a c6 zr1 setup repainted bc no one will go to the c7 and 5th gen camaro/6th gen camaro setup yet.

Thats what threw me off because I know the ATS spindles are C5/C6 brake setup. Where did you find the correct Brembo and Z/28 logos to put back on the calipers? Mine have some chips so I was going to have to repaint them anyways.

rideordie28 · #5 02-18-2020, 04:32 PM

Quote:

Originally Posted by CamaroAJ

Thats what threw me off because I know the ATS spindles are C5/C6 brake setup. Where did you find the correct Brembo and Z/28 logos to put back on the calipers? Mine have some chips so I was going to have to repaint them anyways.

I used Porsche silver powder coat and a high temp vynal sticker from Ebay. Might clear over it might not. Have not decided

**WSSix** · #6 02-18-2020, 07:41 PM

Glad you're back on it. Best of luck making progress!

**Spiffav8** · #7 02-18-2020, 10:51 PM

Heck yeah!!

rideordie28 · #8 02-24-2020, 01:04 PM

Does anyone have recommendations on a good on header heat shield. I have the long tubes on both side very close to the firewall and near where the gm factory lt4 create harness has to run. This is ghb going to need to be addressed. The area I have will basically make the heat shield ride on the header and the harness most likely will touch the shield.