Camaro LT5

[WSSix]

Nice work on the exhaust. Are those made mufflers or bought? The welds make it look custom made.

[WILWAXU]

Originally Posted by WSSix

Nice work on the exhaust. Are those made mufflers or bought? The welds make it look custom made.

Originally Posted by Stielow

Up next week is exhaust. Because Holley make a kit now hopefully it will go quick. But like everything on these car I wanted to modify the “off the shelf” system.

Holley did some one off mufflers to knock down the sound pressure.

https://lateral-g.net/forums/showpos...&postcount=268

[jmac]

Thanks for the update!
Have more questions for you, I know, I'm that annoying kid in class that asks all the questions

What are the tabs/brackets circled below?





We know you and most everybody makes those trunk notches in order to route the exhaust up over the rear, but in this one pic, it looks like there's a section taken out from the rear seat area. What was that for?



As always, thanks for sharing and your time!

[Stielow]

Originally Posted by jmac

Thanks for the update!
Have more questions for you, I know, I'm that annoying kid in class that asks all the questions

What are the tabs/brackets circled below?





We know you and most everybody makes those trunk notches in order to route the exhaust up over the rear, but in this one pic, it looks like there's a section taken out from the rear seat area. What was that for?



As always, thanks for sharing and your time!

The holes in the top photo are pass throughs for the diff vent, fuel tank vent Two Much Canisters. Also a pass through for wiring.

The tab in the middle photo is the pickup point for a brace brace that reinforces the pan hard rod. I’ve added this to my last 4 build to stiffen up the DSE bracket.

The last photo is the clearance hole we cut into the floor pan for exhaust clearance. We will fill patch it once the exhaust is done. It gave us a ton of extra room for the 3 inch pipe to go over the axle.


Sent from my iPhone using Tapatalk

[Stielow]

Originally Posted by jmac

Thanks for the update!
Have more questions for you, I know, I'm that annoying kid in class that asks all the questions

What are the tabs/brackets circled below?





We know you and most everybody makes those trunk notches in order to route the exhaust up over the rear, but in this one pic, it looks like there's a section taken out from the rear seat area. What was that for?



As always, thanks for sharing and your time!

A couple photos of the pockets in the floor pan to clear the kick ups over the rear axle.






Sent from my iPhone using Tapatalk

[jmac]

Awesome. Thanks for the follow up pictures.

I can now see clearly those other holes on the left, they go through to the trunk for your vents and wiring.

I'd like to see how that other bracket works to strengthen the panhard bar mount if you have pics of that complete.

Thanks!