'69 Camaro Temper

[214Chevy]

Man, that looks good. I like it...

[CamaroAJ]

Not much of an update, lacking some motivation to get stuff done and lacking some parts to give me motivation. I did get started on the fuel filler though. I got the area above the tank cut out to make the fill connection. This will be made into a bolt together cover once I have the pipe built. In order to check for enough drop I had to weld the driver inner wheel well in place. I had to finish fitting it a little bit before it was 100% ready to weld in. After that I located a place to put the filler cap. Not where I wanted to put it, but because of how the tank is I was really limited and I didn't want to put it on the body. With that kinda laid out I built a trunk support now that the wheel well is in the correct location.

[streetbird]

love that custom work

[CamaroAJ]

Originally Posted by streetbird

love that custom work

Thank you.

Saturday I still wasn't very motivated to do anything on the car, but it needs done so I got some stuff done. I got some more riv-nuts so I was able to get those installed. I relaly like the Hammer fab dimple dies, they make for a really clean install. First up was finishing the HVAC mount and getting those riv-nuts installed. Its pretty solid with 3 mounting points. Then I added 3 to each rocker extension so I can mount the inner fenders once I get to that stage.






Then I moved onto the rear bumper. I had 2 of the mounts done and needed to finish up the 3rd. I got it finished up and then did some adjusting to the drive side mount and got everything panel bonded together.



With the bumper drying and having the panel bond already out I got the mounting tabs done for the third brake lamp and bonded to the spoiler. Pretty happy with the fitment and I'll be able to wet sand the brake lamp to finial fit the spoiler and then finish it off with a smoked candy tint to help blend it in and not stand out.