While working with the Nicop for the brake lines I made a crossover for the two back steam ports. I drilled and tapped the factory block off ports to accept the line.
Intake, throttle body and fuel rails installed. Working on the front accessory drive. Using the Holley low mount with fourth gen Camaro spacing. The integral power steering pump reservoir will fit but cant get the lid off without unbolting the crossbar. I am going to have to come up with a remote mount solution.
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Threaded Mode