Early second Gen Camaro from Wheel well clearance

[67XR7]

Originally Posted by dontlifttoshift

Cutting it out just leaves a sharp edge to rub on. How bad does it rub? Takes a bit of paint or changes lanes when you hit a bump?

You could:

Leave it

Dial in more camber

Hit the inner fender with a big hammer

Buy wheels that fit


8" wheel needs about 5" of backspace and 1* of negative camber if you want the car low and not rub on the outside.

It’s rubbed a good amount of paint off. Going to drive it a little more and see how it goes. If i cut it I’m not going to just leave it open but build a little pocket and weld it closed. These wheels are 2-3 years temporary while I knock out an LS swap.